Wall-mounting is the best way to have a charger accessible yet out of the way. I’ve got the Makita DC18RC, which does not have holes for easy mounting. I have however found a suitable holder on Thingiverse. This is a quick 3D print. After removal of the rubber plugs, it fits into the four holes on the bottom. You can then screw it to the wall or, as in my case, mount it to a strip of wood that fits a French cleat wall.
Earlier this year, AutoBild tested several 1/2″ ratchet/socket sets (the test was later republished in AutoBild Klassik). Perhaps unsurprisingly, German A-brand Hazet […]
A decent set of screwdrivers is probably the most essential part of your tool kit. My choice in this regard is the […]
A shop vac is an important ingredient of every workshop, especially for woodworking. Dust collection not only keeps your workshop clean, it […]
I’ve recently leafed through Setting up a home car workshop again, and while I still think that it’s a good book, I […]
